Fiberglass REPAIREZY™
Description
Fibreglass damage? Here’s the smart way to repair chips, gouges, and drill holes like a pro.
Fibreglass RepairEzy™ is a super-tough, pre-coloured filler that repairs, colours, and seals fibreglass and gelcoat damage in one application.
Like other MagicEzy products, Fibreglass repair is powered by nanotechnology, so particles seep deeply into the damage to deliver industrial grade adhesion. It’s highly elastic too, so it absorbs shock and helps prevent further damage.
Better still, repairs last. Nanotechnology deeply penetrates into the damage to deliver industrial grade adhesion. It’s highly elastic too so it absorbs shock and helps prevent further damage.
SUITABILITY
- FIXES: Holes, chips, cracks, and gouges over 1mm. For fine cracks and scratches use Hairline Fix instead.
- WORKS ON: Fibreglass, acrylic, porcelain, enamel, ceramic, wood, carbon fibre, dry wall, ceramic, stone.
- FINISH: Gloss.
- USE IT EVERYWHERE: Boat, jet ski, shower, tub, sink, tiles counter top, porcelain, acrylic, enamel, stone.
- PRE-TINTED: White, Blue or Blue & White Kit.
- ULTRA STRONG NANOTECHNOLOGY
- 60-day Customer Satisfaction Money Back Guarantee.
COLOUR
Available in 2 colours:
- White
- Blue & White
- Blue
Colour Disclaimer
Actual colours may vary. This is due to computer monitors displaying colours differently and everyone can see colours differently. We try extremely hard to ensure our images are as accurate as possible, but please understand the actual colour may vary slightly on your monitor. For recommendations, please contact us via email or telephone. Please note any advice given by our staff is based on the information provided at the time by the customer.
TECH SPECS
- Water soluble, one-part epoxy.
- UV and water resistant (above the waterline use only).
- High fill-rate / minimal slump.
- Can be applied to vertical surfaces.
- Can be sanded and drilled.
- No primer required.
- Suitable for use at temperatures above 70°F / 20°C.
- In cool temperatures use a hairdryer to set for 2 minutes.
- Vol. 12.9ml / 0.43 fl oz.
APPLICATION INSTRUCTIONS
- Using a needle scrape dirt grime from cracks.
- For quality fibreglass boat repair and general fibreglass repair, scrub soapy water in the affected area to remove any dirt or grime. Rinse and fully dry.
- Shake and Knead the tube/s for 2 minutes.
- Apply 2 drops of Fibreglass RepairEzy™.
- Gently level the repair with the end of the tube.
- Immediately remove smears and clean LEVEL with a damp tissue. Repeat if necessary.
- If required, polish after 48 hours.
Wet areas:
Seal after 1 hour with clear sticky/scotch/cello tape for 14 days.
Deep damage:
Repeat every 2 hours for 2/3 times.
Temperatures below 20C/70F set repair with a hairdryer for 2 Minutes.
Safety Data Sheet